P Pro HVAC
Union City, OH · 45390 Ohio · 24/7 line

Furnace Ignition and Pilot Light Repair in Union City, OH Near Me

Pilot light going out or furnace clicking without lighting in Union City, OH? Pro HVAC connects you with an HVAC professional. Call (321) 463-9811.

Call (321) 463-9811 More services
Ohio Statewide
Symptom-First Matching
24/7 Emergencies
No Obligation

A furnace that clicks, hums, then falls silent without heat is failing somewhere in its ignition sequence. On newer systems the usual culprits are a cracked or worn hot surface ignitor, a flame sensor coated in oxide so it cannot prove flame, or a pressure switch that will not close because the flue or condensate line is blocked. On older standing-pilot units, a pilot that lights but will not stay lit usually points to a failing thermocouple or a draft reaching the pilot assembly.

These faults follow a diagnosable order and a professional will work through it rather than replacing parts on guesswork. Repeated ignition lockouts should not be reset over and over, since each attempt puts unburned gas into the chamber. Pro HVAC connects homeowners in Union City, OH with HVAC professionals. Call (321) 463-9811.

How it works

Four simple steps to Furnace Repair in Union City, OH

01

Tell us the symptom

Tell us what your system is doing in Union City, OH.

02

Matched to the fault

We match the symptom to a professional who handles that fault.

03

They contact you

They contact you directly to arrange the visit.

04

If it is not right

If they cannot help, tell us and we find another.

Coverage

Furnace Repair Services Across Union City, OH

Covering Union City, OH and nearby ZIPs across Ohio.

ZIP codes we serve

45390
Furnace Ignition And Pilot Light Repair in Union City, OH

Furnace Ignition And Pilot Light Repair FAQs

Frequently asked questions about Furnace Ignition and Pilot Light Repair

Questions we hear most often about Furnace Ignition and Pilot Light Repair in Union City, OH.

Talk to a real person
What causes my furnace to short cycle on and off?
Short cycling is most often caused by a dirty filter or blocked return vents that make the unit overheat and shut down. Replace the filter, clear vents, and make sure supply registers are open. A thermostat placed in direct sunlight or near a lamp can also cause rapid cycling. In Union City, OH winters this wastes fuel and stresses the heat exchanger.
Why does the pilot light on my furnace keep going out?
A weak thermocouple or drafts around the burner compartment usually cause the pilot to extinguish. First, ensure the furnace door is fully closed and the area around the unit is free of strong air currents. If the pilot still will not stay lit after relighting per the label instructions, turn the gas valve off and do not attempt further adjustments.
What should I do when there is no heat overnight in Union City, OH winter?
Check the thermostat batteries and confirm the switch is set to heat. Replace the furnace filter if it is dirty, then verify the breaker is on. If the furnace still does not respond, turn the system off at the breaker to prevent further damage. Call (321) 463-9811 for referral to a local technician who can diagnose the issue safely.
Do I need an AC recharge, or do I have a refrigerant leak?
A sealed air conditioning system does not use refrigerant up, so if the charge is low there is a leak somewhere. Cooling that weakens season after season, ice on the line set, or a hissing sound near the indoor unit all point to a leak rather than normal top-up. Adding refrigerant without locating the leak means paying again next season, and running low charge makes the compressor run hot. Ask for the leak to be found and quoted before agreeing to a recharge in Union City, OH.
Why is my ductless mini split not cooling or dripping water?
A mini split head that runs but will not cool usually has a low refrigerant charge from a flare-joint leak, a blocked outdoor coil, or a failed fan or compressor capacitor. Water dripping from the indoor head is almost always the condensate drain, which relies on a gravity fall or a small pump that clogs with biofilm. A blinking timer or operation light is a stored fault code that tells a technician which sensor or board is reporting. In Union City, OH these units often serve additions, attics and finished basements where they are the only heating or cooling in the room.

Talk to an Ohio HVAC repair

Need Furnace Repair in Union City, OH? Call now.

Describe the symptom and we connect you with an Ohio HVAC repair pro for Furnace Repair or Emergency HVAC Repair. Call (321) 463-9811.

Call (321) 463-9811 Browse services
Call (321) 463-9811 Services